05.
Precise Movement Control
1. Video Mode:
In this mode, you can set the speed level from 1 to 10 using the Speed knob. For instant direction change, use the centre knob by rotating it clockwise or counter clockwise.
2. Interval Mode:
In this mode, you can set the slider's travel distance according to its length (600 / 900 / 1200 mm) using the Speed/Direction knob. Direction control is also handled via the same knob. The side knob is used to control both the distance and pause time between movements.
a.) Length (in mm) – Adjust the total length of camera travel on the slider from 600/900/1200 mm, through the Speed/Direction dial.
b.) Distance (in mm) – Decide the Distance of each segment, from 1-300mm, to be covered on the total chosen length through the right Interval dial.
c.) Pause (in sec) – Set the period of short breaks, from 1-999 seconds, according to your needs while the camera travels on chosen length through the left Interval dial. The number of breaks is automatically aligned when both Length & Distance parameters are tuned and are achieved by advanced algorithms programmed within the controller.
3. Loop Mode:
This mode offers fully pressure-sensitive control. The system automatically changes direction when it reaches a stopper or end point. You can place stoppers as needed to define the range of motion. In this mode, only the Speed knob is used to control movement speed.5
